Denver, CO 80231 • www.americanlighting.com
©
2014
American Lighting, Inc. RV1411 Page 1 of 2
LED Magnum 8” Downlight
WARNING: These products may represent a possible shock or re hazard if improperly installed or attached
in any way. Products should be installed in accordance with these instructions, and with current electrical
codes and/or the current National Electric Code (NEC). This light module is intended to be installed only by
qualied personnel.
WARNING: To avoid electric shock, disconnect power at source prior to installation.
Save these instructions.
Alteration of the xture will void the warranty.
Do not make or alter any open holes in a wiring enclosure, nor in any electrical components during kit
installation! WARNING: Risk of re or electric shock. Kit installation requires knowledge of recessed lighting
luminaires electrical systems. If not qualied, do not attempt installation. Contact a qualied electrician.
SUITABLE FOR USE IN DRY AND DAMP LOCATIONS; AND TYPE IC LOCATIONS.
Do not use these products in areas where elevated ambient temperatures exist. This xture is suitable for
installation where ambient temperatures do not exceed 104˚F (40˚C) during anticipated hours of fixture
operation. This fixture is airtight certified. Not for use in dimming circuits.
WARNING: Risk of re or electric shock. The electrical rating of this product is 120-277V AC. The installer must
determine that the supply is within the range of 120-277V AC at the luminaire before installation.
WARNING: To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
This product cannot be disassembled. The LEDs are not replaceable. If the LEDs become damaged, the xture
should be disconnected and recycled. Failure to do so may result in electric shock, and become a re hazard.
FUTURE LAMP REPLACEMENT: Model MAG8-XX-XX (8” MAGNUM LED Downlight) is available from American
Lighting, Inc. Contact 800-880-1180 or visit www.americanlighting.com to find a local distributor.
NEW CONSTRUCTION/REMODEL/RETROFIT: No rough-in can needed! Best practices include use of a laser to mark
fixture locations on floor for finish electrical; and removing any existing housings through cut-out hole or through
plenum as needed.
CAUTION: Always make sure power to the xture is disconnected before beginning of removal of
existing lamp and/or trim, or beginning installation. Failure to do so can cause electric shock, which
can result in injury or death.
INSTALLATION
1. Using the cut-out template supplied with the xture, mark and cut a 8.07 inch round hole in the ceiling
where the xture is to be mounted. See Figure 1.
Installation instructions for MAG8 Series
Figure 1
Cut-out template = 8.07”
(205mm) diameter
8.07 in
Knockouts
are located
on two
sides of
junction
box
Junction
Box
Cover
Figure 2
2. Remove attached junction box cover and set aside. Punch out whichever knockout is best suited for
connection to supply wires. Knockouts are located on the sides of the junction box. See Figures 1 and 2.
(CONTINUED ON REVERSE)
9.05 in
5.38 in
2.67 in
7.74 in
Four knockouts (two on opposing sides) for use with 1/2” conduit and
3/8” clamp connectors (not included with xture).
Commentaires sur ces manuels