American-lighting AL-PWM-6A Manuel d'utilisateur télécharger pdf

WARNING:

These products may represent a possible shock or fire hazard if improperly installed or attached in any way. Products

should be installed in accordance with these instructions, current electrical codes and/or the current National Electric Code (NEC).

For installation in a standard wall box designed for use with wall dimmers and wall switches.

PLEASE READ THE FOLLOWING CAREFULLY BEFORE PROCEEDING!

CAUTION - To reduce risk of fire, electric shock or injury to persons:

1. BE SURE THAT SUPPLY POWER IS DISCONNECTED AT THE SOURCE BEFORE PROCEEDING!

2. DO NOT OPEN THE DIMMER OR ATTEMPT TO SERVICE - THIS COULD CREATE A SHOCK HAZARD

AND/OR DAMAGE THE DEVICE!

DO NOT CONNECT 120V AC POWER TO THIS DEVICE. IT MUST BE POWERED ONLY BY 12V

OR 24V DC (CONSTANT VOLTAGE) POWER.

4. For all wire-to-wire connections, use UL Listed wire nuts.

5. Do not exceed 6 amps of load connected directly to the dimmer. For larger loads, see installation instructions for the

Constant Voltage Drivers (PS-25/60/100/150-12/24), taking note how to use the LED Repeater (part number AL-3R-6A)

in conjuction with the dimmer and multiple drivers.

LED PWM Dimmer

Installation instructions for AL-PWM-6A

www.americanlighting.com

RV-1229R2