American-lighting FL-501 Manuel d'utilisateur
Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage American-lighting FL-501. American Lighting FL-501 User Manual Manuel d'utilisatio
- Page / 1
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
©2013 American Lighting
Denver, CO 80231 Made in China
www.americanlighting.com
LED PANORAMA PRO FLOOD LIGHT
Installation instructions for FL-101, FL-201, FL-301, FL-501
RV-1328
Figure 1
Side bolts
Yoke mounting bracket
READ ALL OF THESE INSTALLATION INSTRUCTIONS BEFORE INSTALLING THE FIXTURE. FAILURE TO FOLLOW
INSTALLATION INSTRUCTIONS AND ALL APPLICABLE ELECTRICAL CODES WILL VOID THE PRODUCT WARRANTY.
WARNING:
These products may represent a possible shock or fire hazard if improperly installed or attached in any
way. Products should be installed in accordance with these instructions, current electrical codes and/or
the current National Electric Code (NEC).
WARNING:
Disconnect supply power from the source prior to installation. This product must be installed by a
person familiar with the construction and operation of the product and the hazards involved, and in
accordance with current electrical codes and/or the current National Electric Code (NEC). Consult a
local licensed electrician if you are not sure about the installation. To reduce potential of electric shock,
fixture must be grounded.
Do not mount or support these fixtures in a manner that can cut the outer jacket or damage the wire
insulations. Do not restrict fixture ventilation. Do not cover fixtures with insulation or any material that
will impede air flow around and heat dissipation of the fixtures. Control on/off functions via switched
branch circuit.
APPLICATION / USE:
This product is suitable for use in wet locations and designed for surface mounting only.
The xture comes
with a yoke mounting bracket which can be easily combined with a variety of accessory mounting
hardware. This xture is suitable for installation where ambient temperatures do not exceed 95˚F (35˚C)
during anticipated hours of fixture operation.
INSTALLATION:
Disconnect supply power from the source prior to installation.
1. Remove old fixture if applicable.
2. Attach fixture to desired bracketry via the center hole using
corrosion resistant 5/16” bolt, lock washer and nut (not
provided); or lag screw. Lag screws or 5/16” bolts may be used
in the slotted holes if needed. See Figure 1.
Mark positions of mounting holes and drill with appropriately
sized bit. Attach bolts, then tighten nuts securely applying
proper torque. Yoke can be used with a variety of durable,
corrosion resistant
bracketry that can support fixture’s weight.
3. Attach weatherproof compression fitting to weatherproof
junction box cover and route jacketed lead wire through fitting.
For photocell and/or motion sensor operation, consult
manufacture’s instructions and use appropriate weatherproof
junction box cover and weatherproof fittings.
4. Connect fixture’s lead wires to AC supply wires using
appropriate UL Listed electrical connectors as follows: Connect
ADDITIONAL SAFETY MEASURES:
1. LEDs are not serviceable. Do not attempt to open the fixture or LED compartment.
2. LEDs are bright. Do not look directly into fixture.
3. Not intended for recess mounting in any type of installation.
4. Do not use with wall dimmers or in dimming circuits.
Note: These instructions do not cover all details or variations in equipment nor do they
provide for every possible situation during installation, operation or maintenance.
line voltage (hot) AC supply wire (Black) to the line voltage AC wire (Black); connect neutral (common) AC
supply wire (White) to the neutral AC wire (White); and connect the ground AC supply wire (Green or bare
wire) to the ground AC wire (Green wire).
5. To aim the light, loosen the side bolts connected to the yoke mounting bracket and adjust the the fixture
up or down. Re-tighten side bolts to secure the fixture in the desired position. See Figure 1.
1
Résumé du contenu
Page 1 - LED PANORAMA PRO FLOOD LIGHT
©2013 American LightingDenver, CO 80231 Made in Chinawww.americanlighting.comLED PANORAMA PRO FLOOD LIGHTInstallation instructions for FL-101, FL-201,
Produits connexes et manuels pour Éclairage American-lighting FL-501
(2 pages)© 2020, manymanuals.fr. Tous droits réservés | 1.165 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels